Volkswagen IDF rear drop camber plates


Volkswagen IDF rear drop camber plates


These MK1, 2 and 3 CNC machined Drop plates re-position the stub axle on the rear beam giving the rear of the vehicle either a 35mm or 65mm drop, depending which configuration they are installed. They also add 2° of camber to the rear wheels. With the plates installed, a lower ride height can be achieved while maintaining maximum suspension travel. This will also put the rear beam at less of an angle, positioning the rear wheels further back and closer to the center of the wheel arches. Grade 10.9 mounting Hardware and Loctite 243 packets provided.
Works with drum or disk brakes, with or without ABS on either level of drop.

The MK4 Drop plates are designed for bagged/lowered cars, these plates mount to the rear beam, relocating the hub to provide up to 23mm of drop, center the wheels in the wheel well, and add 2* of camber. Grade 10.9 mounting Hardware and Loctite 242 packets provided.
The 2* of camber is designed to offset the thickness of the plate leaving the top of the tire within 5mm of its location before installation.

Also available with 3° or 4° camber (at an additional cost). In that case, please contact us.

Vehicle Fitment:
Volkswagen MK1 MK2 MK3 Corrado/Scirocco/Golf/Jetta /Cabrio
Volkswagen B3 Passat
Volkswagen MK4 Golf/Jetta/Beetle
Audi MK1 A3 (8L)
Seat Leon MK1
Seat Toledo MK2
Skoda Octavila MK1

*Bolt on installation requires removal of rear wheel bearing.
*Bolts securing drop plates must be torqued to 47 ft/lbs with supplied loctite applied to clean threads.

Choose “Type of Car” for MK1, 2, 3 or 4.

Additional information

Weight 3 kg
Type of Car

MK1/2/3, MK4

Brand Euro Car

Audi, Seat, Skoda, Volkswagen

Mounting Side


You may also like…